INSTRUCTIONS FOR USE
Parenteral drug products should be inspected visually for particulate matter and discoloration prior to administration, whenever solution and container permit. Do not use if color is darker than pale yellow, if it is discolored in any other way, or if it contains a precipitate.
Instructions for use - Carpuject™ Single-dose Cartridge
Carpuject™ Single-dose cartridges with Luer Lock are packaged in a Slim-Pak™ tamper detection package. Note that a needle is not included.
Before use, read all instructions for using the Carpuject™ Syringe, which are contained in the product insert for the reusable Carpuject™ Holder.
Carpuject™ Single-dose cartridges are to be used ONLY with Carpuject™ Holders.
NOTE: To prevent needlestick injuries, do not recap, purposely bend, or break by hand used needles. Do not recap, purposely bend, or break by hand blunt Cannulas.
Instructions for use - iSecure™ Single-dose Syringe
- 1.
- Remove green tamper evident band in a clockwise motion.
| |
|
- 1.
- Depress (Push) the plunger rod. This will loosen the plunger rod that is located on the outside of the syringe barrel so that the plunger rod can be removed. This will also engage the syringe.
| |
-
- Remove the plunger rod.
| |
-
- Insert the plunger rod into the back end of the syringe barrel and turn clockwise 2 to 3 times to attach.
| |
-
- BEFORE REMOVING LUER TIP CAP, hold the syringe with tip cap upright. Press syringe plunger until plunger moves slightly. This motion breaks the seal between plunger and syringe barrel.
| |
- 1.
- Twist the luer tip cap clockwise or counterclockwise to break the tamper evident label. Remove the luer tip cap and discard it.
Expel the air by pushing on the plunger rod.
Attach needle or blunt cannula if required.
| |